Eden HA2000 Specifikace stáhnout pdf (Strana 27)

PROBLEM? 11

Do not HESITATE to call us via our assistance hotline (at the end of the notice). Our technicians will have the pleasure to

help you make a perfect installation.

Panel is sounded.

2. The Control Panel will sound swept frequency

alarm tone in high volume.

“Water Alarm”

1. There are two types of Water Alarm:

z For Internal Alarm Water Detector--an alarm

condition where the Control Panel is activated.

z For External Alarm Water Detector-- An alarm

condition where the Control Panel, External Siren

are activated in concert

2. The Control Panel will sound pulsed 4 high-

pitched beeps in high volume.



) When any alarm is triggered while the

Control Panel is in low battery condition,

the Control Panel will sound a broken

swept frequency alarm tone in high

volume to further remind the user to

replace the battery.

VI.StoptheAlarmandAlarm

Display

During any alarm except “Fire” alarm, the Control

Panel will sound its siren while the LCD remains

blank.

During a “Fire” alarm, the Control Panel will not only

sound its siren but also show the following display

automatically:

F I R E!

F I R E !

1. Stopping the Alarm

During an alarm, to stop the siren and clear

display:

Step 1. Key in your PIN code, and then press

“OK”.



) if you press any key other than the first

digit of your PIN code, the screen will

prompt you to enter your PIN code.

Step 2. If the PIN code is correct, then the alarm

sounding will be stopped and the display

will show the source of the alarm:

A l a r m e d b y P I R

Z 0 1 . . . . . . . . . . . .

The sensor which triggers the alarm is

displayed on the top line while its zone

number and name (if entered) are

displayed on the second line.



) All sensors displayed are abbriviated

whereas “C.U.” stands for “Control

Unit”.

Step 3. Press “OK”, the display will be cleared

and replaced with “Alarm Off”.



) Panic Alarm must be silenced at the

Control Panel. This is to prevent the

Remote Controller from being snatched

from the user and silence the alarm using

the Disarm button.

2. Alarm memory

If an alarm was raised without being silenced

during your absence:

z When you come back and disarm the system by

entering your PIN code followed by “OK”, the

Control Panel will sound 5 beeps instead of 2

beeps with LCD display showing the source of the

alarm. You are requested to press “OK” to clear

the alarm display.

z When you disarm the system by a Remote

Controller or Remote Keypad, the Control Panel

will also sound 5 beeps to alert the user that an

alarm has been occurred.

z When the system is in Disarmed mode and the

screen is blank, press any key on the Control

Panel, the memorized alarm events will be

displayed. You are requested to press “OK” to

clear the alarm display first before you can

proceed.



) The alarm event will be memorized and

be displayed unless it is cleared by

pressing “OK” key manually.

VII.FaultySituations

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 40 41

Komentáře k této Příručce

Žádné komentáře

Eden HA2000 Specifikace Strana 27

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu Eden HA2000